• Betofix HB [basic]

    Article No. 108225

    Betofix HB [basic]

    Mineral-based bonding layer

    Colour: grey | 1082
    Size / Quantity

    Brochures and Catalogues

    product.brochures.loading

    Product specifications

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • For use on floors indoors and outdoors
    • Interior and exterior use
    • Bonding layer on mineral building material surfaces

    Properties

    • Plastic-modified
    • High tensile adhesion strength
    • Certified in accordance with DIN EN 1504-3
    • Preparation
      • Preparations

        Concrete surface:
        Stable, clean, dust-free
        Observe the applicable technical regulations for the following parameters:
        - Adhesive pull strength of the substrate
        - Minimum roughness/roughness depth

        Pre-wet the substrate so that it is slightly moist.

        The substrate must have an average pull-off strength of at least 1.5 N/mm²

    • Application
      • Brush
      • Application temperature: min. 5 °C max. 30 °C
      • Application requirements

        Temperature of the material, air and substrate: from min. +5 °C to max. +30 °C

      • Working time (+20 °C): Approx. 60 minutes

         

        Apply the material to slightly damp surfaces.

        Follow-up work must be carried out wet ond wet.

         

    • Working tools / cleaning
      • Brush
      • Mixer, trowel, wide brush, brush, grout broom

      • Clean tools with water while the material is still fresh.

    • Storage / shelf life
      • Protect form moisture
      • Shelf-life 12 months
      • If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.

    • Usage
      • 1.1 kg / mm thick layer / m²
      • Approx. 1.1 kg/m² per coat

    • General information
      • The mixing water must be of drinking water quality.

        The characteristic data of the product were calculated under laboratory conditions at 20°C and 65% relative humidity.

        Deviations from applicable regulations must be agreed separately.

        The relevant test certificates must be observed when planning and carrying out work.

    • Disposal instructions
      • Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

    • Safety / regulations
      • For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.

    Possible system products