• Protective Coating
    • Protective Coating

    Article No. 2082410

    BIT Primer [basic]

    Solvent-free bitumen emulsion

    Brochures and Catalogues

    product.brochures.loading

    Product specifications

    Base Solvent-free bitumen emulsion
    Density (20°C) Approx. 1 kg/l
    Consistency Liquid
    pH value 11

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • Protective coating for concrete, masonry and render in the subsoil
    • Primer underneath bituminous sealants (PMBC)
    • Capillary sealant

    Properties

    • Water-based
    • Solvent-free
    • Resistant to moisture
    • Resistant to heat and cold
    • Water-dilutable
    • Preparation
      • Substrate requirements

        Clean, dust-free and capable of supporting a load.

        Matt damp surfaces are permitted.

    • Application
      • Application temperature: min. 5 °C max. 30 °C
      • By brush / By roller / Airless/airmix spraying
      • Ready to use, straight from the container.

        Apply several layers of the material on to the prepared substrate.

        Dilute with water if necessary.

        Add mineral mortar products to the mixing water if necessary.

        When using as a primer under bituminous waterproofing materials (PMBCs), dilute with water in a mixing ratio of 1:10.

        In case of sedimentation of the bitumen solid, stir the material with a suitable mixing tool.

    • Application instructions
      • When using liquid-applied materials, direct sunlight and/or wind can cause accelerated skin formation and associated blistering. This effect is amplified on surfaces with a large number of cavities.

        Do not apply any further layers until the previous layer has hardened sufficiently.

        Protect freshly coated surfaces from rain, direct sunlight, frost and condensation.

        Protect dry sealant from mechanical damage and UV radiation.

    • Working tools / cleaning
      • By brush / By roller / Airless/airmix spraying
      • Flat brush, slurry brush, suitable spraying equipment

        Clean tools immediately after use with water.

        Remove dried-on material using V 101 Thinner (0978).

    • Storage / shelf life
      • Store frost-free and cool / protect for moisture / close containers
      • Shelf-life 12 months
      • If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.

    • Usage
      • Depending on the application / m²
      • Priming: at least 0.025 kg/m² (diluted 1:10 with water)
        Protective coating: at least 0.25 kg/m² per coat
        Additive: 30-50 kg/m³ mortar

    • General information
      • Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.

        The relevant test certificates must be observed when planning and carrying out work.

    • Disposal instructions
      • Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

    • Safety / regulations
      • For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.

    Tools, accessories and PPE