Article No. 284230
Water-based primer with a strengthening effect
Product specifications
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Sanding, absorbent mineral substrates
- Under ceramic coverings
- Priming of gypsum-based building materials in interiors
Properties
- Strengthens the surface
- Equalises absorption capacity
- Quick drying
- Aqueous
-
Preparation
-
Substrate requirements
Clean, dry and free of dust and cracks (apart from hairline cracks).
Free of salts known to be damaging to building materials.
-
-
Application
-
Shake well before use.
Depending on the absorbency of the substrate, dilute the material with water in a ratio of up to 1:1.
Apply evenly to the material using a brush, roller or spray.
If needed, repeat the application.
-
Application instructions
-
Wait for the coat to dry fully before applying subsequent coats.
Do not let excess material build up on the surface.
Glossy layers must be avoided.
Structural defects such as cracks, cracked joints, defective connections and rising damp must be remedied first.
Adjacent building elements and materials that are not intended to come into contact with the product should be protected using suitable measures.
-
Drying
1 to 6 hours depending on the application rate, building material and ambient conditions
-
-
Working tools / cleaning
-
Low-pressure spraying equipment, lambskin roller, flat brush
Clean tools immediately after use with water.
-
Storage / shelf life
-
If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.
-
Usage
-
Approx. 0.1 - 0.4 l/m² depending on the substrate
-
Apply to a large enough trial area to determine the precise amount required.
-
General information
-
The relevant test certificates must be observed when planning and carrying out work.
The current technical regulations must be observed.
Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.
Always set up a trial area/trial areas first.
-
-
Disposal instructions
-
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
-
-
Safety / regulations
-
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.
-