Article No. 109306
Fast repair mortar
Downloads & documents
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Concrete replacement according to
- DIN EN 1504-3
- Concrete replacement for non-structurally relevant repairs
- Repair of pores, missing and broken out areas
- Early strength
- Very low shrinkage
- Well suited to overhead working
- Can be applied by spatula and felted
Stable, clean, dust-free
Observe the applicable technical regulations for the following parameters:
- Adhesive pull strength of the substrate
- Minimum roughness/roughness depth
Pre-wet the substrate so that it is slightly moist.
Temperature of the material, air and substrate: from min. +5 °C to max. +25 °C
(+20 °C): approx. 20 minutes
One layer 1 - 10 mm
Two layers < 20 mm, apply wet on wet
< 100 mm in broken-out areas
Applying corrosion protection:
Apply slurry in 2 layers so that it covers the surface fully
Minimum thickness of each layer: 1 mm
Waiting time between layers: approx. 30 minutes
As per DIN EN 13670 / DIN 1045-3
Working tools / cleaning
Mixer, brush, filling knife, trowel, smoothing trowel, sponge float, plasterer’s float
Clean tools with water while the material is still fresh.
Storage / shelf life
If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.
Approx. 1.4 kg/m²/mm layer thickness
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
Safety / regulations
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.