Article No. 072530
Aqueous deep primer with strengthening and hydrophobising properties
Product specifications
The stated values represent typical product characteristics and are not to be construed as binding product specifications.
Field of application
- Primer for sanding, mineral substrates such as P II and P III
- Weathered old coatings capable of supporting a load
Properties
- Strengthens
- Equalises absorption capacity
- Aqueous
-
Preparation
-
Substrate requirements
Clean, dry and free of dust and cracks (apart from hairline cracks).
Free of salts known to be damaging to building materials.
-
-
Application
-
Apply with a brush, roller or by spraying.
Shake well before use.
If needed, repeat the application.
-
Application instructions
-
Adjacent building elements and materials that are not intended to come into contact with the product should be protected using suitable measures.
Structural defects such as cracks, cracked joints, defective connections and rising damp must be remedied first.
Do not let excess material build up on the surface.
Can be diluted with water depending on the absorbency of the substrate.
Glossy layers must be avoided.
-
Drying
Can be recoated after 12 hours at +20 °C and 65% relative humidity.
As a general principle, higher temperatures will reduce and lower temperatures will increase the times stated.
-
-
Working tools / cleaning
-
Paintbrush, ceiling brush, flat brush, pressure sprayer
-
Clean tools immediately after use with water.
-
Storage / shelf life
-
If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 12 months.
-
Usage
-
Approx. 0.1 - 0.2 l/m² depending on the substrate
-
Apply to a large enough trial area to determine the precise amount required.
-
General information
-
The relevant test certificates must be observed when planning and carrying out work.
The current technical regulations must be observed.
Current regulations and legal requirements must be taken into account and deviations from these must be agreed separately.
Always set up a trial area/trial areas first.
-
-
Disposal instructions
-
Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.
-
-
Safety / regulations
-
For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.
-