All Purpose Stain

Wood building elements with limited or no dimensional stability: wood moisture content max. 18%

The substrate must be clean, dry and capable of bearing a load.

Thoroughly remove any dirt, grease and non-adhering old coatings.

Sand grey and weathered wood surfaces down to sound, bright wood.

Exterior wood that needs to be protected against soft rot and blue stain must be pre-treated with a suitable wood preservative* - not necessary for interior wood (*Use biocides safely. Always read the label and product information before use).

Stir well.

Apply by brush.

Apply in the direction of the grain.

Apply a second coat once the first has dried.

Maintenance coating: 1 - 2 coats with a slight intermediate sanding.

All colours can be mixed with one another.

Use material with the same batch number on contiguous surfaces (mix material of different batches beforehand), otherwise slight differences in colour, gloss and texture may occur.

Seal opened containers well and use contents as soon as possible.

Check colour, adhesion and compatibility with the substrate by setting up a trial area.

Before coating technically modified woods and wood-based materials, apply the coating to a trial surface and conduct a suitability test on the desired area of use.

Only use the clear and white variants on sheltered exterior surfaces, such as roof undersides, or indoors.

Areas that are being coated or dried should be protected against rain, wind, sunlight and condensation.

Approx. 4 hours at 20 °C and 65% relative humidity.

Low temperatures and high humidity delay drying.

If necessary with 5-10% water.

Paintbrush with acrylic bristles, flat brush

Clean tools immediately after use with water and detergent.

Ensure that any residue from cleaning is disposed of correctly.

If stored unopened in its original container in a cool, dry place and protected against frost, the product will keep for at least 24 months.

Approx. 80 ml/m² per coat in min. 2 coats.

DIN EN 71-3 "Migration of certain elements":

This product complies with the limits for the migration of heavy metals to children's toys according to DIN EN 71-3 and thus fulfils one of several further requirements for the safety of children's toys according to the EU "Toy Directive" (2009/48/EC).

Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.