• S-Protect M

    Article No. 091905

    S-Protect M

    Corrosion inhibition additive for Betofix RM/Betofix R2

    Variant
    0919 | S-Protect M
    Size / Quantity

    Product specifications

    Density Approx. 1.03 g/cm³
    Solids content Approx. 47%
    pH value Approx. 8
    Viscosity (4mm flow cup) Approx. 20 s

    The stated values represent typical product characteristics and are not to be construed as binding product specifications.

    Field of application

    • For use on floors/walls/ceilings indoors and outdoors
    • Interior and exterior use
    • Protects against corrosion
    • System component for Betofix RM + Betofix R2

    Properties

    • Active anti-rust pigments
    • Highly water-repellent
    • Alkali-resistant
    • Certified in accordance with DIN EN 1504-7
    • Basic test according to SIB guideline in Betofix RM system
    • Preparation
      • Substrate requirements

        Clean, dust-free and capable of supporting a load.

      • Preparations

        Reinforcement:
        Degree of purity SA 2 ½ if applying corrosion protection, otherwise SA 2

    • Application
      • Application temperature: min. 5 °C max. 25 °C
      • Brush
      • Drying time: can be worked over after 30 minutes
      • Apply two layers of slurry with a thickness of min. 1 mm each, making sure the entire surface is covered.

        Waiting time between layers: approx. 30 minutes.

        Follow-up work must be carried out wet ond wet.

    • Application instructions
      • Once it has hardened, mortar must not be made workable again by adding either water or more wet mortar.

    • Working tools / cleaning
      • Brush
      • Mixing tool, brush

        Clean tools with water while the material is still fresh.

    • Storage / shelf life
      • Store frost-free and cool / protect for moisture / close containers
      • Shelf-life 12 months
      • If stored in an unopened container and in a dry place, the product will keep for approx. 12 months.

    • Usage
      • 3.2 kg mixture in total / m² steel surface
      • Applied in 2 coats, per m² steel surface area approx. 0.9 kg S-Protect M and 2.3 kg material

    • General information
      • The mixing water must be of drinking water quality.

        The characteristic data of the product were calculated under laboratory conditions at 20°C and 65% relative humidity.

    • Disposal instructions
      • Larger quantities of leftover product should be disposed of in the original containers in accordance with the applicable regulations. Completely empty, clean containers should be recycled. Do not dispose of together with household waste. Do not allow to enter the sewage system. Do not empty into drains.

    • Safety / regulations
      • For further information on the safety aspects of transporting, storing and handling the product and on disposal and environmental matters, please see the current Safety Data Sheet.

    Possible system products